1
BTM-2013 division issues
Problem reported by Jim Mars - September 3, 2014 at 1:05 PM
Resolved
Have BTM-2013 Pro, version 6.53.01.  Run a tournament at the Stadium in Reno with divisions based on combined average for doubles and 4-person team.  Last year, during registration, division was automatically assigned as bowlers were added to squads.  This year, after restarting the tournament and making a minor change to the average range, this feature no longer works.  In doubles, every doubles team is assigned to DIV01 no matter what the combined averages are.  Every 4 person team is assigned no division at all.  Even the technical folks at the stadium were stumped.

5 Replies

Reply to Thread
0
Lance Rasmussen [CDE Staff] Replied
September 3, 2014 at 9:08 PM
Employee Post
How did you specifically configure the divisions for doubles and for 4 person team as?
CDE Software Staff
---------------
Remember to always make sure you've downloaded and installed the most current update to see if issues experienced have been corrected.
0
Jim Mars Replied
September 5, 2014 at 3:43 PM
In setup, divisions tab.  
I set up individuals first, women, 90% to 220, men 80% to 220.  
Then doubles, DIV01: 0 - 370 average, DIV02: 371-600 average.  
Then team, DIV01: 0 - 740, DIV02: 741 - 1200
0
Raymond Monroe [CDE Staff] Replied
September 8, 2014 at 10:27 AM
Employee Post
Jim,
 
Go to D-1: Rules Setup and then Division & Handicaps - Doubles. On the top, what is the setting for "Division Assigned?"
0
Lance Rasmussen [CDE Staff] Replied
September 8, 2014 at 5:08 PM
Employee Post
Jim,
 
I think you may need to email a backup of the tournament to help@cdesoftware.com along with the information about what you are intending for the doubles divisions as well as the registration number of the 2 bowlers you said you just added and it not placing in the correct division.
 
I think you still have something incorrectly configured in your division setup, such as gender or average.
CDE Software Staff
---------------
Remember to always make sure you've downloaded and installed the most current update to see if issues experienced have been corrected.
0
Raymond Monroe [CDE Staff] Replied
September 10, 2014 at 9:16 AM
Employee Post
When you set up the division, make sure that the setting are all as you intended. In this case, the Doubles Divisions are separated by average and the setting is for "Highest Bowler's Average" - which means that just one bowler will determine what division the Doubles pair is in. What Jim had set up for the averages this should have been set as "Team Average" so that the bowlers averages are added together to determine which division the team should be in.
 

Reply to Thread